761
This document, and the content contained herein, is intended for customers, users and other persons with the operation and features of the covered Hegla products. While Hegla makes every effort to include accurate and useful information, it is not possible to anticipate or address every possible situation or to account for conditions at unknown locations or interactions with unknown systems or components. Therefor, these documents must be used only for informational purposes and used in conjunction with best practices and with due care. Hegla shall not be responsible for any injuries or losses that occur as a result of the information in this document. Moreover, as products and offerings change over time, the usefulness of the information in this document may become obsolete. It is the responsibility of the reader or consumer to ensure that the information contained herein is timely and reflects the current reality of Hegla products and offerings. Hegla disclaims any and all warranties regarding the information in this document.
***Read chapter 1 of your operators manual before undertaking any work in the area of the servo motor and drive equipment.***
When in doubt please contact Hegla service before taking action (404) 763-9700
Settings for a twin cutting head setup
The settings for the Twin cutting head are made in C:\STDMMI\HEGLA.INI.
Possible settings are:
WKZ_Offset_X= This is the offset from the 1st main cutting head to the 2nd auxiliary cutting head in X direction (measurement in inch = USA, mm = Europe and UK).
WKZ_Offset_Y= This is the offset from the 1st main cutting head to the 2nd auxiliary cutting head in Y direction (measurement in inch = USA, mm = Europe and UK).
Note: if both values are set to 0 then there is no 2 nd cutting head (or it is not in use due to damage)
KopfausgabeType= This determines how the twin cutting heads are used:
0 = machines with more than one physical cutting head where each head is allocated on its own Y- Axis. The post processor analyses the geometries and tries to carry out the cuts in Y- direction simultaneously.
1 = this is similar to setting 0 there is more than one physical cutting head but only one Y- axis. The cutting heads are first brought into position and mechanically fixed before the geometries are simultaneously cut.
2 = this setting is for machines with two cutting heads (and one Y-axis) that are both used to carry out the same function. The switching point between the two cutting heads is set using the glass thickness in the parameter KopfWechselAb= if the glass thickness is less than the set value then the 1st main cutting head is used, if the glass thickness is equal or larger than the set value then the 2nd auxiliary cutting head is used.
KopfWechselAb= sets the value of the glass thickness where the second cutting head is used (measurement in inch = USA, mm = Europe and UK). This is only active when the KopfausgabeType = 2.
EXAMPLE SHOWN BELOW
Extracted out of C:\STDMMI\HEGLA.INI file e.g. Machine # 6313 with two cutting heads [HilfsSchnitt] WKZ_Offset_X=-5.0787 WKZ_Offset_Y=0 KopfausgabeType=2 KopfWechselAb=0.1575 e.g. Single cutting head [HilfsSchnitt] WKZ_Offset_X=0 WKZ_Offset_Y=0 KopfausgabeType=0 KopfWechselAb=0
