27
This document, and the content contained herein, is intended for customers, users and other persons with the operation and features of the covered Hegla products. While Hegla makes every effort to include accurate and useful information, it is not possible to anticipate or address every possible situation or to account for conditions at unknown locations or interactions with unknown systems or components. Therefor, these documents must be used only for informational purposes and used in conjunction with best practices and with due care. Hegla shall not be responsible for any injuries or losses that occur as a result of the information in this document. Moreover, as products and offerings change over time, the usefulness of the information in this document may become obsolete. It is the responsibility of the reader or consumer to ensure that the information contained herein is timely and reflects the current reality of Hegla products and offerings. Hegla disclaims any and all warranties regarding the information in this document.
***Read chapter 1 of your operators manual before undertaking any work in the area of the overhead crane or floor loader equipment.***
When in doubt please contact Hegla service before taking action (404) 763-9700
A defective safety key of a safety option can be replaced by a new safety key.
Replace the safety key as follows:
- Have the original acceptance report available or document the current checksums.
- Switch off the device.
- Replace the defective safety key.
- Switch on the device again.
- In MOVISUITE®, open the "Assist CS.." parameterization tool.
- Load the parameters into the safety option.
- Generate a report.
- Compare the previous checksums with the current checksums. No checksum must have changed. If the checksums differ, check the corresponding functions again.
- Publish the successful acceptance.
INFORMATION
After replacing the safety key of the MOVISAFE® CSA31A safety option, you must perform the referencing of the CSA31A again.
