This document, and the content contained herein, is intended for customers, users and other persons with the operation and features of the covered Hegla products. While Hegla makes every effort to include accurate and useful information, it is not possible to anticipate or address every possible situation or to account for conditions at unknown locations or interactions with unknown systems or components. Therefor, these documents must be used only for informational purposes and used in conjunction with best practices and with due care. Hegla shall not be responsible for any injuries or losses that occur as a result of the information in this document. Moreover, as products and offerings change over time, the usefulness of the information in this document may become obsolete. It is the responsibility of the reader or consumer to ensure that the information contained herein is timely and reflects the current reality of Hegla products and offerings. Hegla disclaims any and all warranties regarding the information in this document.

***Read chapter 1 of your operators manual before undertaking any work in the area of the linear drives equipment.***

Click here to view disclaimer

When in doubt please contact Hegla service before taking action (404) 763-9700

Changing the override speed on a cutting machine:

1. Log into the Service login from the Operator HMI: Service Shift+F3, Service Hegla Shift+F1
2. There is no password, just click the green check mark. If it asks for a password enter the password "STDMMI"
3. You may have to click anywhere on the screen, before pressing F12 to go to the Diagnostic screen
4. You can increase the machine speed with Shift+F6 for "Override +"
5. You can decrease the machine speed with Shift+F7 for "Override -"
6. You can click and drag with the mouse on either of the override buttons to change the speed.