542
This document, and the content contained herein, is intended for customers, users and other persons with the operation and features of the covered Hegla products. While Hegla makes every effort to include accurate and useful information, it is not possible to anticipate or address every possible situation or to account for conditions at unknown locations or interactions with unknown systems or components. Therefor, these documents must be used only for informational purposes and used in conjunction with best practices and with due care. Hegla shall not be responsible for any injuries or losses that occur as a result of the information in this document. Moreover, as products and offerings change over time, the usefulness of the information in this document may become obsolete. It is the responsibility of the reader or consumer to ensure that the information contained herein is timely and reflects the current reality of Hegla products and offerings. Hegla disclaims any and all warranties regarding the information in this document.
***Read chapter 1 of your operators manual before undertaking any work in the area of the linear drives equipment.***
***Read chapter 1 of your operators manual before undertaking any work in the area of the servo motor and drive equipment.***
When in doubt please contact Hegla service before taking action (404) 763-9700
How to use multipass edge deletion with HeglaCut
- Open HeglaCut and make the cutting plan you need. The plan MUST have edge deletion turned on in the article! If you do not know how to make a plan here is a link to a video showing how to create a cutting plan. How to create a cutting plan in HeglaCut
- Once you have made a plan your screen will be similar to the one shown below
- Now you need to right click the lite you would like to do a multipass on and select "Elaborar la capa del vidrio" (shown below)
- Now your screen will look like the one shown below. In the example below we will edge delete 50mm at point 1 and taper down to 0mm at point 2.
- Going further...In the photo shown below we are edge deleting 50mm off the bottom of the light and to the right of the light. Once you have created what you want to edge delete simply click OK and continue with saving the plan.
