PREVENTATIVE MAINTENANCE - Automatic Greaser Installation/Replacement

Michael Zeidler

Apr 25, 2024

649

This document, and the content contained herein, is intended for customers, users and other persons with the operation and features of the covered Hegla products. While Hegla makes every effort to include accurate and useful information, it is not possible to anticipate or address every possible situation or to account for conditions at unknown locations or interactions with unknown systems or components. Therefor, these documents must be used only for informational purposes and used in conjunction with best practices and with due care. Hegla shall not be responsible for any injuries or losses that occur as a result of the information in this document. Moreover, as products and offerings change over time, the usefulness of the information in this document may become obsolete. It is the responsibility of the reader or consumer to ensure that the information contained herein is timely and reflects the current reality of Hegla products and offerings. Hegla disclaims any and all warranties regarding the information in this document.

***Read chapter 1 of your operators manual before undertaking any work in the area of the overhead crane equipment.***

Click here to view disclaimer

When in doubt please contact Hegla service before taking action (404) 763-9700

Automatic Greaser Installation/Replacement

To install or replace a greaser follow the instructions below:

Setup Atlanta- Schmierbuechse 31-4071-0960 (complete unit)

Always change complete unit (Batteries, Gas and Grease)! The hoses and felt wheels are "optional".

Complete unit: 31-4071-0960

Grease cartridge: 31-4071-0081

Gas cartridge: 31-4071-0080

Hoses: 31-4071-0975 (sold by meter)

Felt Wheel: 31-4071-0965

Shaft for felt wheel: 31-4071-0970

Switch 1-6 = Months before empty (Standard 6 Months = switch 4 on & Switch 7 on). Once you have the dip switches set on the new unit simply replace the old with the new.